![]() ZHop Height: 3 (THIS IS IMPORTANT, if not the printer will cut during travels).speed is optional but you will have to slow it down a bit for stunning results.set all the temperatures to 0 degrees, both bed and nozzle.This should only take a few minutes.įollow the assembly instructions in this YouTube video: Īdjust the Z offset of your printer, since the blade will be lower than the nozzle to prevent interference.Ĭreate a sketch of the line you want the blade to follow in your preferred 3D CAD software (e.g., Fusion 360).Įxtrude the sketch by 0.12mm, which corresponds to the minimum height accepted by the printer.Įxport the sketch in Stereolithography Mesh (.stl) format and open it in your preferred slicer software.Ĭreate a custom profile in your slicer software and save it as "Plotter" or something similar. This holder extends lower than the nozzle to prevent interference.Īssemble the pen holder by connecting part_A and part_B using the 2mm screws. Print the required parts for the plotter pen holder. STEP TO CONVERT YOUR ENDER S1 INTO A PLOTTER: NOTE: this mode is compatible with my "ENDER 3 S1 / PRO PLOTTER CONVERSION MOD" ( ) and the tolls heads are interchangeable.Ī pen big enough to fit tightly into the "Pen_holder_A", I personally suggest the following: Pentel Hybrid gel grip ( ) as i found these to work best. ![]() It's easy to install and to convert it back and forward you will not need any tools. This is a mod to convert your Ender 3 S1 into a pen plotter.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |